Sharp LL-T2010W Mode D'emploi page 11

7. Analog RGB input terminal . . . . Remove the cover to see the analog RGB input terminal. At the time
8. Power terminal . . . . . . . . . . . . . Remove the cover to see the power terminal. The AC adapter is
9. Security lock anchor . . . . . . . . . By connecting a security lock (commercially available) to the security
10. Analog signal cable . . . . . . . . . Connects to the computer's analog RGB output terminal.
11. USB port . . . . . . . . . . . . . . . . . . Remove the cover to see the USB port (upstream: 1 port,
12. DVI-I input terminal . . . . . . . . . . Remove the cover to locate the DVI-I input terminal (DVI-I29 pin).
13.Ventilation openings . . . . . . . . . Note: Never block the ventilation openings as this may lead to
Product description
Rear view
of leaving the factory the analog signal cable is connected.
connected here.
lock anchor, the monitor is fixed so that it cannot be transported.
The security slot works in conjunction with Kensington Micro Saver
Security Systems.
downstream: 2 ports).
The computer's digital RGB output terminal or analog RGB output
terminal can be connected here.
For a digital signal input: It can be connected to a computer with a
DVI-compatible output terminal (DVI-D24 pin or DVI-I29 pin) and
which has UXGA output ability. Depending on the computer to be
connected, correct display may or may not be possible.
To be able to connect, a cable that is to be purchased separately is
required.
To connect to a digital RGB output terminal: Digital signal cable
(model name: NL-C01E)
To connect to an analog RGB output terminal: Analog signal cable
(model name: NL-C02E)
overheating inside the monitor and result in malfunction.
11