Accessories; Standard Accessories; Optional Accessories; Optional Accessories...sold Separately - Hitachi DH 26PC Mode D'emploi

English
WARNING
ALWAYS use Only authorized HITACHI replacement parts and accessories. Never use replacement parts or
accessories which are not intended for use with this tool. Contact HITACHI if you are not sure whether it is
safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Plastic Case (Code No. 335257) (for DH26PC) .........................................................................................................1
(Code No. 370155) (for DH26PF, DH28PFY) .......................................................................................1
(2) Side Handle (Code No. 335273) ...............................................................................................................................1
(3) Depth Gauge (Code No. 310331) ..............................................................................................................................1

OPTIONAL ACCESSORIES...sold separately

1. Drilling anchor holes (Rotation + Hammering)
○ Drill Bit (Taper shank) and taper shank adaptor
(1) Drill Bit (Taper Shank)
External dia.
7/16" (11 mm)
1/2" (12.3 mm)
1/2" (12.7 mm)
9/16" (14.3 mm)
9/16" (14.5 mm)
11/16" (17.5 mm)
7/8" (21.5 mm)
14

ACCESSORIES

(2) Taper Shank Adaptor
(SDS-plus shank)
Cotter (Code No. 944477)
Code No.
944460
944461
993038
944462
944500
944463
944464
Taper mode Code No.
Morse taper
303617
(No. 1)
Morse taper
303618
(No. 2)
A-taper 303619
B-taper 303620
○ 1/2" (13 mm) Hammer Drill chuck and Chuck wrench
For drilling operations when using a straight shank bit
for impact drilling with a rotary hammer
Impact Drill
Application
Straight shank Bit
Applicable drill bit
7/16" (11 mm)
1/2" (12.3 mm)
Drill bit
1/2" (12.7 mm)
(Taper
9/16" (14.3 mm)
shank)
9/16" (14.5 mm)
11/16" (17.5 mm)
Drill bit
(Taper 7/8" (21.5 mm)
shank)
Taper shank adaptor
formed A-taper or B-taper
is provided as an optional
accessory, but drill bit for it
is not provided.
1/2" (13 mm) Hammer Drill
Chuck (SDS-plus shank)
(includes Chuck wrench)
Chuck wrench