Helios KWL EC 700 D Pro Notice De Montage Et D'entretien page 53

Installation and Operating Instructions
Menu 18 – HW test
16 -
16 - Freecooling Free cooling
17 - PID-Param.
17 - PID Params
18 - HW test
HW-Test
20 - 20 - Modbus RTU
Modbus RTU
21 - 21 - Network
Network
All connected components and accessory parts are tested in the HW
TEST menu. These parameters are not saved.
Supply air fan output
F in
Extract air fan output
F out
Pre 1 Control pre-heater battery
H 1 Test the auxiliary heater (heating requirements in %)
By/Ro Open/close bypass valve
Ext1 Outside air temperature sensor
Ext2 Supply air temperature sensor
Ext3 Supply air duct sensor
Int1 Extract air temperature sensor
Int2 Exhaust air temperature sensor
Menu 20 – Modbus RTU
17 -
17 - PID Params
PID-Param.
18 -
18 - HW test HW-Test
20 - Modbus RTU
Modbus RTU
21 - Network 21 -
Network
23 -
23 - User lock User lock
Central Ventilation Units KWL EC.. D Pro/WW
19
The Modbus communication is set via the Modbus RTU menu.
Menu 21 – Network
18 -
18 - HW test HW-Test
20 - Modbus RTU
20 - Modbus RTU 20 - Modbus RTU
21 - Network 21 - Network
Network
23 - User lock
23 - User lock 23 -
User lock
49 - 49 - Other setting
Other settings
Network parameters
Address IP
Mask
Gateway
The network is used to set the network communication of the unit (ModBus
TCP).
Menu 23 – User lock
20 -
20 - Modbus RTU Modbus RTU
20 - Modbus RTU
21 - 21 - Network Network
21 - Network
23 - User lock
23 - User lock User lock
49 -
25 - Factory reset 49 - Other setting
Other settings
50 -
50 - Factory reset
Factory reset
EN