Helios KWL EC 700 D Pro Notice De Montage Et D'entretien page 51

Installation and Operating Instructions
Menu 09 – Temperature sensor
07 -
Heater battery
08 -
AQS Sensor
Temperature sensor
10 -
Supply air duct limit
11 - Bypass temperature
Temperature probe
Blowing
Suction
Surroundings
Supply air duct:
Temperature sensor for the supply air in the building.
Extract air duct:
Temperature sensor for the extract air in the building.
Room:
The temperature sensor (option) installed in the measurement area for
connection to circuit board A1 terminal 55-56.
Menu 10 – Supply air duct limit
08 -
AQS Sensor
09 -
Temp. sensor
Supply air duct limit
11 - Bypass temperature
12 - Airflow deviation
Maximum
temperature
supply air duct
Meze foukání
Minimum
temperature
supply air duct
It is recommended to keep the flow rate reduction activated.
If the sensor in the supply air duct is selected, a maximum tempera-
ture cannot be set at the same time.
Central Ventilation Units KWL EC.. D Pro/WW
Target temp.
sensor to set
the unit
Activate or deactivate the unit
output reduction if the minimum
temperature is not reached
(activated as standard).
17
Menu 11 – Bypass temperature
09 -
Temperature sensor
10 -
Supply air duct limit
Bypass temperature
12 -
Airflow deviation
13 -
Emergency airflow
Posun toků
Odtok 0 %
Minimum outside air temperature at which bypass can be opened.
Range 0-20 °C.
Menu 12 – Supply air flow deviation
10 -
Supply air duct limit
11 -
Bypass temperature
Airflow deviation
13 - Emergency airflow
15 - Boost
Posun toků
Odtok 0 %
EN
Set the air
flow deviation
(positive pres-
sure, negative
pressure)