Helios KWL EC 700 D Pro Notice De Montage Et D'entretien page 50

Installation and Operating Instructions
EN
Menu 04 – Fan calibration
The calibration takes a few minutes. Do not cancel this process. During
calibration, the unit determines the maximum pressure loss and the
maximum air flow when the fan runs at full speed.
NOTE! The unit will not function properly if the distribution
network is not complete during calibration, or if the flaps or
valves are not closed, etc.
Menu 05 – Filter calibration
The filter calibration must be carried out for the initial calibration and after
a filter change.
Central Ventilation Units KWL EC.. D Pro/WW
01 -
Mode
02 -
Hw setting
Fan calibration
05 -
Filter calibration
07 -
Heater battery
flow
02 -
Hw setting
04 - Fan calibration
Filter calibration
07 -
Heater battery
08 -
AQS Sensor
Menu 07 – Heater battery
Calibration
Heater battery activation option.
Menu 08 – AQS sensor
Select AQS
sensor
16
04 -
Fan calibration
05 - Filter calibration
Heater battery
08 -
AQS sensor
09 - Temperature sensor
05 -
Filter calibration
07 -
Heater battery
AQS Sensor
09 -
Temperature sensor
10 -
Supply air duct limit
Probe DCV
Without
Limit DCV
Set the limit value
for air quality
sensors