HAIRCUT TH24ST Guide De L'utilisateur page 26

EN
 When the trimmer is not in use, it is recommended to clip the cutter cover (Fig. 1-K)
onto the blade.
Use with or without power lead
 With a new, fully charged battery, the trimmer can be used without the power lead for
about 100 minutes. The LCD shows the remaining autonomy (Fig. 1-R).
 Before the end of the autonomy period, the charge light flashes (Fig. 1-S). Recharge the
trimmer, refer to § 3.1.
 The trimmer can be used with power lead. For this, connect the cable to the trimmer
(Fig. 2a) and connect the power pack (Fig. 1-H) to a mains power socket.
3.3 ADJUSTING THE CUTTING HEIGHT
 Press the centre button (Fig. 3a) and push the sliding knob. Select a trimming height:
0.4 – 0.6 - 0.8 mm.
 Release the centre button.
3.4 USING THE COMB ATTACHMENTS
 The trimmers must be switched off. Select a comb attachment: 3, 6, 9 or 12 mm (Fig. 1
refs. M-P).
 Place the comb attachment on the blade (Fig. 3b) and clip in at rear. When the comb
attachment is correctly fixed, it is immobilized.
 To remove the comb attachment, unclip by the rear tab (Fig. 3b).
3.5 USING THE TURBO FUNCTION
 Activating the Turbo function: press the button (Fig. 1-C). The indicator comes on. The
trimming speed and power are increased by about 20%.
 Disabling the Turbo function: press the button again (Fig. 1-C).
3.6 LUBRICATING THE TRIMMERS
After 30 minutes of use, it is recommended to lubricate the trimmer.
Stop the trimmers and place the sliding knob in 0.8 mm position (Fig. 3a).

Removing the blade: hold the blade with your thumb and press on the spot

shown by the arrow (Fig. 5a).
Apply 1 drop of lubricating oil to the 5 points shown (Fig. 4b).

Use only the oil supplied.
Install the blade by first inserting the rear part (Fig. 4c). Press the blade with

your thumb to clip it on.
 Switch the trimmer on for a few seconds after lubricating.
26