HAIRCUT TH24ST Guide De L'utilisateur page 25

 The equipment must only be used with
the power pack it was supplied with.
 WARNING: To recharge the battery, use
only the removable power pack supplied
with the equipment.
When charging, it is recommended to switch off the trimmer (On/Off button in OFF
position, Fig. 1-D).
Charging trimmers from mains
 Insert the electrical lead into the socket of the trimmer (Fig. 2a).
 Connect the power pack (Fig. 1-H) into a mains power socket.
 When charging, the red light (Fig. 1-S) comes on. The battery is fully charged when the
LCD indicates 100. The autonomy time is then 100 minutes.
 When completely charged, disconnect the power pack. The trimmer can now be used
without the power lead.
Charging the battery on the charge stand
 Insert the electrical lead into the charge stand socket (Fig. 2b).
 Connect the power pack (Fig. 1-H) into a mains power socket.
 Put the trimmer on the charge stand and proceed as described above.
 When completely charged, the trimmer can be used without the electrical lead.
3.2 OPERATION
When first used, lubricate the blades by applying a drop of oil to the points shown
(Fig. 5).
Switching on/off
 Switch the trimmer on by pressing the On/Off button (Fig 1-D). The red button comes
on.
 To stop the trimmer, press the On/Off button again (Fig. 1-D). The button goes off.
Use only
ZDJ045100EU power pack.
25
EN
with the