YORKVILLE MP8DX Guide De L'utilisateur page 5

3. MAIN EFFECTS MASTER CONTROL 3. MAIN EFFECTS MASTER CONTROL 3. MAIN EFFECTS MASTER CONTROL 3. MAIN EFFECTS MASTER CONTROL
The MAIN EFX master control regulates the amount of signal going from the output of
the internal DIGITAL EFFECTS PROCESSOR to the MAIN mixing bus where it is mixed
with the dry signals direct from the channels. It controls overall effects intensity on the
MAIN output signal and RECORD OUT signal as well as through the main PA speakers.
interconnected power amps, with the MAIN output signal while the internal power
amplifier is also functioning (although it is not necessary to have speakers connected -
e.g. if you want to use the unit strictly as a mixer).
The AMP A IN jack is a direct input to the MAIN 400 Watt power amplifier, it is referred to as
AMP A. An alternative use for the AMP A IN jack is as a patching input. Because this is a
switching jack, when you plug into it, you interrupt the internal flow of the signal going from
the output of the Main mixing bus to the input of the built-in 400 Watt power amp. This allows
you to insert signal control devices such as an élite processor, an additional equalizer, or a
compressor/limiter into the Main signal path. It is even possibleto connect another mixer to the
's power amplifiers via the AMP A IN jack. This slaves the amplifier to that mixer's signals
MP8
DX
(i.e. it no longer receives the built-in mixer's signals), which means that you could use the built-
in mixer to do another, totally separate mixing job. For example, you could patch the MP8
MAIN output to an input on another mixer connected to amps driving a PA speaker system
while using the MP8 's internal A amp to power control room speakers.
DX
4. MONITOR EFFECTS MASTER 4. MONITOR EFFECTS MASTER 4. MONITOR EFFECTS MASTER 4. MONITOR EFFECTS MASTER
CONTROL CONTROL CONTROL CONTROL
The MONITOR EFX master control
regulates the amount of signal going
from the output of the internal
DIGITAL EFFECTS PROCESSOR to
the MONITOR mixing bus where it
is mixed with the dry signals direct
from the channel MON send
controls. It controls overall effects
intensity of the MONITOR LINE
OUT signal.
5. MAIN LINE OUT 5. MAIN LINE OUT
5. 5. MAIN LINE OUT MAIN LINE OUT
& AMP A IN JACKS & AMP A IN JACKS
& AMP A IN JACKS & AMP A IN JACKS
These jacks can serve a variety of
patching and routing purposes. The
MAIN LINE OUT is positioned in
the signal path after the MP8
main graphic equalizer and is
therefore regulated by it (i.e. it is
post-EQ).
The main bus signals are
available at line level (not speaker
level, use the SPEAKER outputs on
the back panel to drive speakers)
from the MAIN LINE OUT jack.
Taking a signal from this jack has no
effect on the operation of the MP8
built-in power amplifier. It is
therefore possible to feed an external
power amplifier or even several,
's
DX
's
DX
's
DX
3