Safety Instructions; Technical Specifications - Trixie REPTILAND Mode D'emploi

terrarium. This is to assist the heat flow and prevent
excessive heat accumulation. If necessary, place small
objects under the lamp to raise it higher above the
terrarium surface.
• Ensure adequate ventilation to help prevent small
areas overheating.
• Switch the lamp on and off with the switch on the
power cable.
• When installing the lamp with a clamp fixture, ensure
that the lamp is fixed securely. The lamp must not be
attached to pipes!
Terrarium inhabitants must have the opportunity to
retreat out of reach of the lamp. Temperature gradients
and places to retreat to are essential parts of a terrarium
habitat and help improve the well-being of your pets.
Please follow the manufacturer's instructions when using
bulbs with UV radiation.

Safety Instructions:

• Do not hang the lamp on the power cable without
installing the pull-relief.
• Regularly check the holder, power cable, switch and
plug for signs of damage. If signs of damage are found,
switch the lamp off immediately and do not use it any
more. The same applies if the bulb comes into contact
with liquids. Check-ups or repairs must be carried out
by a qualified electrician!
• Before implementation, it is advisable to check that
this device is suitable for the required use. If you
have any questions, please consult an expert or the
manufacturer.
• Do not use the lamp in humid environments.
• Disconnect the electrical supply before changing
the bulb.
• Use the protective mesh to prevent contact with the
bulb. Also ensure that the hottest parts of the lamp
are not touched.
• The lamp must only be used on flame resistant or
inflammable surfaces and not covered, for example,
with a blanket. Risk of fire! Flame resistant surfaces
must have an ignition temperature of at least 200°C
and must not soften or deform. For example, they
may consist of wood or wood-based materials over
2 mm thick.
• Only use the power cable provided by the manufac-
turer to connect the lamp. If a damaged power cable
needs to be replaced, only use a special cable, or one
obtained from the manufacturer. An inspection must
6. 7.
be carried out by an expert after inserting/replacing
the power cable, before the next use of the lamp.
• Do not use UV bulbs in rooms with human access. Do
not look directly at the lamp.

Technical Specifications:

Operational Voltage
230 V~50/60 HZ
Switching Current
max. 1.3 A
Maximum Ambient Temperature
45 °C
Maximum Input Voltage
depending on the model, up to 100 W or up to 250 W (see
specifications on packaging)
Safety Distance
consult the manufacturer's information for the relevant
bulbs.
Suitable Bulbs:
The following bulbs are suitable for use with this product:
• reflector bulbs (filament) and light bulbs (e.g.
'REPTILAND Basking Spotlight)
• halogen spotlights (e.g. 'REPTILAND HeatSpot Pro'
Halogen Basking Spotlight)
• UV compact bulbs (self-ballasted energy saving bulbs
e.g. 'REPTILAND Tropic Pro Compact')
• ceramic heat spotlights with E 27 sockets (e.g. 'REPTI-
LAND' Ceramic Infrared Basking Spotlight)
Please adhere to the instructions for use and data speci-
fications of the bulbs, especially the recommended safe
distances for spotlight surfaces.
5