Directions For Use; Operating Conditions - Trixie REPTILAND Mode D'emploi

Directions for Use

Warning:
This item should only be installed or uninstalled by a
qualified electrician.
Make sure that the lamp is not connected to the mains
supply during installation. No liability can be assumed for
damage resulting from improper installation.
Mounting on a surface:
Diagram 1
Unscrew the ring from the ceramic holder. It is necessary
to push down on the metal pin in the centre, using for
example, a biro or screwdriver.
Diagram 2
Remove ring and reflector or protective mesh.
Diagram 3
Unscrew the headless screw to disconnect the pull-relief.
Diagram 4
Remove the inner section of the socket and disconnect
the cables from the screw contacts.
Diagram 5
Unscrew the threaded bolt from the ceramic holder and
remove the lower washer and the nut. Drill a 10 mm hole
in the surface on which you want to attach the lamp (flame
resistant). Thread the cable and mounting accessories
through the hole from above and use the nuts to secure
it from both sides.
Diagram 6
Screw the holder back onto the threaded bolt. Ensure that
the threaded bolt does not extend too far into the holder,
in order to avoid contact between the ends of the cables
and the electrical contacts.
1.
4
2. 3.
Diagram 7
Replace the reflector or protective mesh back on the holder
and attach the ring. Check that the inner part of the holder
is correctly positioned. The metal pin should click into place
and the cable must not be twisted. Screw the headless screw
back in to connect the pull-relief.

Operating Conditions:

• The device may only be operated at 230 V, 50/60 Hz
AC voltage.
• The permitted ambient temperature of 45 °C must not
be exceeded during operation.
• The device is designed for use in dry areas.
• Ensure an acclimatisation period of up to 2 hours if
condensation occurs.
• Protect the device from moisture and water splashes!
• Do not operate the device in areas in which flammable
gases or vapours may exist.
Designated Usage:
This device is for indoor use only. All bulbs listed in this
manual can be used (see the section 'Suitable Bulbs').
This device is designed to be mounted on flame resistant
surfaces (not flammable surfaces!). Improper use or
mounting is not permitted!
Use in a Terrarium:
The installation inside a terrarium is at your own risk. As
the company TRIXIE has no influence over the operating
conditions in the terrarium, it is the responsibility of
the consumer to ensure safe and appropriate conditions
for use.
Initial Operation and Operation:
• Before the first use, insert a bulb into the E 27 socket
and plug the mains plug into a suitable plug socket.
• For lamps with covered reflectors: If the lamp is
on the top of the terrarium, make sure that there is
space between the reflector and the surface of the
terrarium, and that the reflector does not touch the
4.
5.