DeWalt DWX723 Guide D'utilisation page 5

Pull the extendable extension arm out to the desired length. Turn
the extension arm lock lever clockwise to lock.
DW7231 D WALT Miter Saw Mounting
E
Method (Fig. 6, 7)
WARNING: To reduce the risk of injury, turn unit off,
disconnect machine from power source before assembling the
miter saw to the miter saw stand. An accidental start-up can
cause injury.
WARNING: Stability Hazard. You must use the Universal
Miter Saw Mounting Method when mounting a miter saw not
manufactured by D WALT to this miter saw stand.
E
WARNING: To reduce the risk of personal injury, be sure the
miter saw is fully anchored on the stand.
WARNING: For your own safety, read and understand the miter
saw instruction manual before using. Failure to heed these warnings
may result in personal injury and serious damage to the miter saw
and the accessory.
1. Place saw in operational position with blade facing you. Align
with label on the mounting bracket showing front.
2. Place a spacer, such as a 2 x 4, under one side of the miter saw
to hold the saw's mounting feet above the work surface.
3. Hold a mounting bracket under the saw and feed a carriage bolt
(hardware bag) up through the bracket and the foot of the saw.
NOTE: See DW7231 Hardware Selection Chart for the correct
mounting hardware procedures for D
all instructions properly, otherwise the miter saw's table rotation
may be obstructed.
WALT miter saws. Follow
E
4. Once the carriage bolt (hardware bag) is installed per DW7231
3
DW7231 HARDWARE SELECTION CHART
Left Side
DW703 1
DW705 1
DW706 1
DW708 1
DW712 1
DW713 1
DW715 1
DW716 1
DW717 2
DW718 3
1 = Long screw, Head on bottom
2 = Short screw, Head on bottom
3 = Long screw, Head on top
Hardware Selection Chart, assemble a flat washer, lock
washer and nut onto the bolt. Tighten the bolts finger tight.
Right Side
1
1
1
2
2
1
1
1
1
2