Recharging The Battery; Choice Of Gear; Set The Direction Of Rotation; Torque Setting - Parkside PBSA 12 D4 Traduction Des Instructions D'origine

GB IE
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red => Battery needs to be charged

Recharging the battery

Allow a hot battery to cool before
charging.
Charge the battery (10) when only
the red LED on the level indicator is
illuminated.
PAPK 12 A1
charging
time (hour) PAPK 12 A2
PAPK 12 A3
PLGK 12 A1
PLGK 12 A2
PLGK 12 B2
1. Remove the battery (10) from the appli-
ance if necessary.
2. Plug the battery charger (13) into a
mains outlet.
3. Insert the battery (10) in the charging
compartment of the battery charger
(13).
4. Pull the battery (10) out of the battery
charger (13).
5. Unplug the battery charger (13) from
the mains.
Overview of the LED indicators on
the charger (13):
Green LED illuminated while the
rechargeable battery is not inserted:
Charger is ready
Green LED lights up: Battery is charged
Red LED lights up: Battery charging
Red LED flashes: Error
24
PAPK 12 B1
PAPK 12 B2
PAPK 12 B3
1 2
1 2
0,5 1
Choice of gear
Slide the gear selector (5) to 1 or 2,
corresponding to a low or high torque
selection.
1st gear .............................0-350 min
2nd gear .........................0-1300 min
A gear change may only be per-
formed in standstill mode!
Set the direction of
rotation
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
The arrow on the direction switch indicates
the working direction.
1. Wait for the device to shut-down.
2. Clockwise direction: Press
direction switch (6) to the right.
3. Anticlockwise direction: Press
direction switch (6)
to the left.
4. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.

Torque setting

You can preset the maximum torque by ro-
tating the torque adjustment ring (3).
19+1 torque levels are provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 -->
Step
-->
lowest torque,
highest torque.
-1
-1