External Commands - Gram FV Série Manuel D'utilisation

A. key
The data from the balance will be output only by pressing the
balance.
b. External command output mode
A command from a peripheral device connected to the balance will perform
turning on/off the balance, calibration, mode selection, weighing unit
conversion and printing.The balance would send a feedback whether the
command is valid or invalid, as soon as it received a command from the
peripheral device. Err'ill be displayed if the command is invalid.

ExTERNAL COMMANDS

1. <O> <CR> <LF> ON/OFF command (4F 0D 0A) as same as that of
key on the balance.
2. <T> <CR> <LF> Tare command (54 0D 0A) as same as that of
key on the balance.
3. <C> <CR> <LF> Calibration command (43 0D 0A) as same as that
of key
4. <M> <CR> <LF> Mode selection command (4D 0D 0A) as same as
that of
<P> <CR> <LF> Print command (50 0D 0A) as same as that of
5.
key on the balance.
18
output mode
on the balance.
key on the balance.
key on the