R-Net Control System; R-Net Control System Information; Controller Mounts; General Warnings - Quickie Jive M2 Sedeo Ergo Manuel D'utilisation

9.0 R-net Control System

9.1 R-net control system information

An alternative control system called R-net is available for the
wheelchair.
The R-net system has extended options and is suitable for
individuals with complex needs or when there is a preference
for screen based menu options and information displays.
The R-net control system offers simple, effective solutions
to many situations, thereby enhancing the lifestyle and
independence of the user.
The operation of the R-net wheelchair control system is simple
and easy to understand. Both the R-net and VR2 control
systems incorporates state-of-the-art electronics, the result of
many years of research, to provide you with ease of use and a
very high level of safety.
Because of the comprehensive nature of the R-net control
system, a separate R-net Owner's Manual is supplied
whenever this system is fitted.
The R-net control system can be programed to suit the drive
performance needs of the user. The R-net control system
can be programmed via a hand held or PC programmer.
Programming can significantly change the drive profiles of the
wheelchair: For this reason programming must only be carried
out by your approved Sunrise Medical dealer/service agent.
Please refer to the R-net Owner's Manual for details
of R-net hand control functions.

10.0 Controller Mounts

10.1 General warnings

WARNING!
• Do not replace the joystick knob with any unauthorised
item. It may cause hazardous operation and loss of
control of the chair.
• It is important that the joystick boot is replaced if it is torn
or brittle; failure to do so could cause substance damage
to the controller and unexpected movement of the chair.
• Ensure that you always have comfortable access to the
controls whilst the chair is moving and make sure that the
controller is fixed securely to the chair.
• To avoid unexpected or unintentional movement of
the wheelchair and to conserve battery power, it is
recommended that the control system is switched Off
when drive or seating adjustments are not being used.
32
Jive M2 Sedeo Ergo

10.2 Parallel swing-away general warnings

WARNING!
• Before adjusting the swing-away arm, switch off the
controller to avoid accidental displacement of the
joystick which would cause unwanted movement of your
wheelchair.
• Be aware that the width of your chair has increased if
the swing-away arm is out and you may not get between
certain obstacles.
• Do not hang any items on or over the parallel swing-away
remote assembly as this could damage the swing-away
mechanism.
• When transferring to and from the wheelchair do not use
the remote as a means of support.
• Ensure the power is switched off while adjusting the
parallel swing-away arm.
• Only operate the wheelchair at low manoeuvring speed
when the parallel swing-away is in use.
Rev.2.0