Makita DUN500W Manuel D'instruction page 13

7. Align the protrusions on the shear blades vertically
at the same position.
► 1 . Protrusion
8.
Attach the felt pad to the shear blades.
► 1 . Felt pad
9. Insert the protrusion on the shear blades to the
hole on the rod, then align the position of the felt pad
with the holes on the tool, and then attach the sleeves.
1
3
1
1
► 1 . Felt pad 2. Protrusion 3. Hole 4. Sleeve
NOTICE:
inner periphery of the hole of the rod.
NOTICE:
10. Align the holes on the sleeves and the shear
blades with the holes on the tool, and then tighten 2
bolts to fix the shear blades.
► 1 . Bolt 2. Hole
13 ENGLISH
1
4
Apply a small amount of grease to the
Be careful not to lose the sleeves.
1
2
2