Makita DUN500W Manuel D'instruction page 12

1. Place the tool upside down, and then remove 6
bolts.
► 1 . Bolt
2.
Remove the cover, gasket, plate A and plate B.
► 1 . Cover 2. Gasket 3. Plate A 4. Plate B
NOTE: The gasket or plates may remain on the cover.
3. Remove the rod and the bearing.
1
2
► 1 . Rod 2. Bearing
NOTE: The rod or bearing may remain on the cover.
4. Remove 2 bolts, 2 sleeves, and the felt pad, and
then remove the shear blades.
1
1
► 1 . Felt pad 2. Bolt 3. Sleeve 4. Shear blades
2
NOTICE:
5. Remove the blade cover, and then attach it to the
3
new shear blades.
4
6.
Adjust the crank so that 2 holes are lined up on
the alignment line.
► 1 . Hole 2. Alignment line
12 ENGLISH
1
2
3
Be careful not to lose the bolts.
2
4
1