Unit Operation; Programming The Module - Fracarro KDSR Instructions D'emploi

They must be connected to the clip hook and are used to keep all modules separated at an equal
distance. The output signal is already filtered and amplified with a variable level (adjustable by a step
of 1 dB by the TPE programmer).
SUMMARY OF THE RANGE:
MODEL MODULATOR TYPE
KDSR QPSK receiver with VSB E2-E69 modulator, PAL B/G standard, audio mono
KDSR-S QPSK receiver with VSB E2-E69 modulator, PAL B/G standard, audio stereo
KDSR-M QPSK receiver with VSB E2-E69 modulator, multistandard (PAL I, N, H,...)
KDSR-AV QPSK receiver with A/V outputs on RCA connector
Connect the receiver to a KP K series feeder and wait until the green LED starts to flash; this means
that the module reset (bootstrap) is completed and the module is ready to be used; connect TPE.
Summary table of the LEDs status:
LED status
Red LED
Fixed green LED
Flashing green LED
Green LED Off
To program and display the internal state of KDSRs, use the TPE universal programmer. Connect the
programmer to the RJ45 outlet on the module front panel; TPE will switch on automatically.
IMPORTANT: to save the set parameters, press the TPE "S" key. If you don't press the S key within 5
minutes from the last change, the set data will be lost.
The following are the programming menus of KDSRs
SETTING THE INPUT
PARAMETERS (SEE 1.0)
SETTING THE OUTPUT
PARAMETERS (SEE 2.0)
MEASURES RELEVANT TO
THE INPUT SIGNAL (SEE 3.0)
Attention: It is also possible to set the TPE language in the TPE SETUP
Choose language and confirm it with the

UNIT OPERATION

Reason
Module in error. To restore the proper operation, disconnect and reconnect the power
cable. Contact the nearest assistance centre if the problem continues.
The receiver is working properly, the transponder is received correctly, and the front-
end and MPEG decoder are both working properly.
The receiver is not detected
- the receiver is not power supplied
- the module is broken
- the module is booting up (wait a few seconds)

PROGRAMMING THE MODULE

INITIAL MENU - KDSR
INPUT
OUTPUT
MEASURES
key.
THE KEY IS USED TO CONFIRM AN ENTERED
VALUE OR TO ENTER A MENU.
THE KEY IS USED TO CANCEL AN ENTERED
VALUE OR TO EXIT FROM A MENU
S
THE KEY IS USED TO SAVE CHANGES
ARROW KEYS ARE USED TO SCROLL
THROUGH THE MENU ITEMS
NUMERIC KEYS ARE USED TO ENTER VALUES
10
LANGUAGE menu.