Saw Blades, Other Accessories; Sawing With Special Base Runners; Sawing With The Angle Table - Festool CARVEX PSC 420 EB Guide D'utilisation

Use only original Festool accessories and Festool
consumable material intended for this machine.
These components are designed specifically for
this machine. Using accessories and consumable
material from other suppliers will most likely affect
the quality of your results and limit warranty
claims. Machine wear or your own personal work-
load may increase depending on the application.
Protect yourself and your machine, and preserve
your warranty claims by always using original Fes-
tool accessories and Festool consumable material!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festoolusa.com".

Saw blades, other accessories

In order to saw different materials quickly and clean-
ly, Festool offers saw blades for all applications that
are specially designed for your Festool jigsaw.

Sawing with special base runners

7 8
The special base runners protect high-quality sur-
faces against scratches and scores.

Press in the base runner at position [7-1].

At the same time, push the base runner forwards.

Mount another base runner and push it to the
rear until it engages.

Sawing with the angle table

The angle table WT-PS 400 is used for cutting pipes
or interior and exterior angles up to 45°.
Dust extraction is not possible when sawing
with the angle table!
Accessories
Installing the angle table

Remove the saw base [1-10], (see chapter
Changing saw table).

Position the angle table against the saw base
support.

Close the lever [1-8].
Ensure that the angle table is firmly seated in the
guide.
Setting the angle

Turn the adjusting wheel [8-1] to select the re-
quired angle.
You can select the angles -45°, 0° and +45° on the
scale [8-2] .
Sawing cutting depths
Risk of injury

Select the saw blade length and cutting depth so
8-1
7-1
that the saw blade remains plunged in the work-
piece.
 For 90° cuts, we recommend setting the angle
table to a small negative angle to guarantee
smooth operation.
8
9
WARNING
8-2
9-2
9-1
8-1
15