Working With The Electric Power Tool; Service And Maintenance; Accessories - Festool Trion PS 300 EQ Notice D'utilisation D'origine

Always use a splinterguard when working
with extraction to prevent the extraction
channels from becoming blocked.
► Insert the extraction adapter in the rear
opening of the saw table so that the
hook [2-7] engages in the recess [2-8].
► To remove the extraction adapter, press the
lever [2-6].
8 Working with the electric
power tool
WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
8.1 Free guidance along a scribe mark
The triangular shape of the splinterguard [4-3]
indicates the cutting line of the saw blade. This
facilitates sawing along a scribe mark.
8.2 Plunging without pre-drilling
In order to produce plunge cuts in wood work­
pieces, the saw table must be in the forward
position (base position, see fig. [1]).
► Position the saw onto the workpiece with
the front edge of the saw table
► and plunge the saw into the workpiece at
the maximum stroke rate and in pendulum
stroke setting 3, see fig. [6].
8.3 Temperature cut-out (only PS 300 EQ)
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the m-tor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.com/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.com/service
5
3
2
1
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
9.1 Cleaning the chip ejection opening
Clean the chip ejection opening [2-9] regularly
to prevent blockages:
► Remove the chip guard.
► Use a brush or vacuum cleaner to clean the
chip ejection opening.
► Reinsert the chip guard.
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.

10 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".
10.1 Festool FS guide system
Using the Festool FS guide system (fig. [7])
makes it easier to produce straight and precise
cuts, especially with material thicknesses of up
to 20 mm. This involves the jigsaw being inser­
ted in a guide rail adapter [7-1] (order no.
490031), which is used to guide it along the
guide rail. In order to set it to have zero play,
there are two adjustable guidance jaws [7-2] on
the guide rail adapter. Only use cross-set saw
blades when using the guide rail adapter. We
recommend the S 75/4 FSG Festool saw blade.
10.2 Parallel side fence
The parallel side fence (order no. 490119) al­
lows the jigsaw to be guided in parallel with the
edge of the workpiece. The parallel side fence
can be installed from both sides of the saw ta­
ble:
► Slide the clamp [8-1] onto the saw table
from the front.
English
17