Working With The Machine; Acoustic Warning Signal; Service And Maintenance - Festool CARVEX PSC 420 EB Notice D'utilisation D'origine

C A R V E X
GB
8

Working with the machine

CAUTION
Material with high dust generation (e.g.
plasterboard)
Damage to machine through dust pene-
tration, risk of injury
Do not work overhead!
When working on small or thin workpieces, al-
ways use a stable base, or the CMS module
(accessory).
When working, hold the electric power tool by
the handle and guide it along the desired cut-
ting line. For precise cuts and smooth running,
use two hands to guide the electric power tool.
Free saw guidance along a scribe mark
The triangular pointer on the splinterguard
[5-1] indicates the cutting line of the saw
blade. This facilitates sawing along a scribe
mark.
8.1 Lighting
WARNING
The stroboscope light may make it diffi-
cult to determine the saw blade position
Risk of injury
Ensure the work area is well illuminated.
A continuous light or stroboscope is installed
for illuminating the cutting line:
up to approx. 2100 rpm: continuous light
from approx. 2100 rpm: stroboscope light
In overhead position (+/- 45°), the lighting
is switched off completely.
If required, you can adjust the lighting:
Plug in the electric power tool.
Press both buttons simultaneously [1-2]
and hold for approx. 10 s until a beep
sounds.
Release both buttons [1-2].
Press the left button (on the pendulum
stroke side) to select the stroke speed and
consequently the desired operating mode:
20
All manuals and user guides at all-guides.com
Mode
1
2
3
8.2
Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
peep ― ―
peep peep ―
peep peep peep
9
Risk of injury, electric shock
EKAT
Indication dur-
ing configuration
Light flashes
Light on
Light off
Press the right button to save the setting.

Acoustic warning signal

Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stres.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or
has overheated.
– Once
cooled,
check using the charger.

Service and maintenance

WARNING
Always disconnect the battery pack from
the machine before any maintenance or
care work!
All maintenance and repair work which re-
quires the motor housing to be opened,
must only be carried out by an authorised
service workshop.
Customer service and repair
only through manufacturer or ser-
vice workshops: Please find the
nearest address at:
www.festool.com/Service
Use only original Festool spare
4
parts! Order No. at:
www.festool.com/Service
5
3
2
1
Behaviour dur-
ing operation
With strobo-
scope (standard)
Permanent light
without strobo-
scope
Light switched off
the battery pack
perform a functional
has