Environment - Festool Trion PS 300 EQ Notice D'utilisation D'origine

English
► Slide the parallel side fence [8-2] from the
side through the clamp into the desired po­
sition.
► Close the rotary knob [8-3].
10.3 Core maker
The core maker (order no. 490118) can be used
to create circular cuts with a diameter between
120 and 720 mm. The core maker can be instal­
led from both sides of the saw table:
► Slide the clamp [8-1] onto the saw table
from the front.
► From the side, slide the core maker [8-4]
into the desired position through the clamp.
► Close the rotary knob [8-3].
► Insert the circle tip [8-5] into the rear hole
of the core maker.
10.4 Festool CMS
When combined with the Festool CMS system,
the jigsaw becomes a semi-stationary bench
saw for profiled cuts. See the CMS brochure for
more information.
10.5 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations that are specially designed for your
Festool jigsaw.

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach
18