Clean The Stainless Steel - Arneg Belgrado 2 Manuel D'installation

B e l g r a d o 2 - L o n d o n 3
E n g l i s h
Material
• use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C).
• Immediately remove all traces of
water and detergent with a dry
Glass
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
o r t h e g l a s s d o o r h i n g e s .
Pitch
1
Procedure
2
for disas-
3
sembly of
4
the sliding
closure
5
devices
6
7
1
• use a cloth soaked in neutral deter-
Plastic
g e n t
(door seal
• clean with a cloth soaked in clean
profiles)
water
Aluminium • Use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C).
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
f r o m f o r m i n g .
Wood • Use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C).
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
f r o m f o r m i n g .
• If necessary, before treating the en-
tire surface, test on a small hidden
area and verify that the cleaner will
not damage the finish or colour

24. 6 Clean the stainless steel

Certain situations can cause the formation of rust on the surfaces in steel, such as:
54
V D L -V D A -S E L F -H 125-H 150
Remedy
slide the glass lids towards the centre
move the lids upwards to make them come out from the lower rail guides
rotate the lower part towards the operator
remove the lids
gently place them on a flat surface protected by a soft cloth, DO NOT break or
d a m a g e t h e m
clean as indicated in the glass parts cleaning section (chap. 23.5)
Reinstall the closing devices
DO NOT use hot water on cold glass surfaces;
the glass could crack and injure the operator.
DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
DO NOT use dirty cloths
gently place them on a flat surface, DO NOT
break or damage them
Action
2
DO NOT use waxes, concentrated detergents,
which contain oil, bleach, glass cleaners, abra-
sive detergents or flammable fluids
DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
What to avoid
3-4
05060165 00 15-04-2016