Loading Of The Battery - Atlantic Muraux DOJO Notice D'installation Et D'utilisation

3. LOADING OF THE BATTERY

1. Remove the battery cover.
2. Load the batteries as illustrated (2 AAA /LR03 batteries); resetting key (cylinder).
Be sure that the loading is in line with the" + "/"-";.
3. Load the battery, then put on the cover again.
Note :
• The distance between the signal transmission head and the receiver hole should be within 7m
without any obstacle as well.
• When electronic-started type fluorescent lamp or change- over type fluorescent lamp or
wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the
signals, so the distance to the indoor unit should be shorter.
• Full display or unclear display during operation indicates the batteries have been used up.
Please change batteries.
• If the remote controller can't run normally during operation, please remove the bateries and
reload several minutes later.
Wall mounted DOJO R32
48