AudioSonic CL-500 Mode D'emploi page 12

Nature Sounds
This clock radio comes with three built-in nature sounds, which can be accessed in
ON mode with the function button and can then be selected with the sound selector
between forest, brook and ocean. The setting is shown on the display.
Radio
Press al. off to turn the radio on. In case nature sounds were selected, press the
function selector, until fm and the frequency (e.g. 106.0MHz) is displayed.
Press vol + or vol - to adjust the volume between v 00 and v 20.
Press tune + or tune – to tune into your favorite station. Short press for manual scan
one IF up or down. One step in FM band equals 0.05MHz. Press and hold to activate
auto scan. When tuning into the next station, scanning stops and the radio station is
played. The frequency is displayed next to the frequency band fm.
Press al. off to turn the radio off.
The radio comes with an FM wire antenna; please unwind for best reception.
Set and Access Station Memory
Press al. off to turn the radio on as usual. Press tune + or tune – to tune into your
favorite station and adjust the volume. Now press and hold clk. set mem, until the
Save further stations to the memory following above steps; altogether 10 station
memories are available.
Press mem + to access and cycle upwards through the station memory.
Set Alarm
Press al. 1 set once to display the alarm setting. Now press and hold al. 1 set for a few
GB-11