Environmental Protection - Ryobi LLCDI1402 Manuel D'utilisation

Perceuse/visseuse compacte à percussion 14.4 volts

page de 127

/ 127
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

OPERATION

REMOVING BITS (See Figure 8.)

Lock the switch trigger by placing the rotation selector

■

in the center position.

Open the chuck jaws.

■

NOTE: Rotate the chuck body in the direction of the

arrow marked UNLOCK to loosen the chuck jaws. Do not

use a wrench to tighten or loosen the chuck jaws.

Remove the drill bit.

■

DRILLING

Check the rotation selector for the correct setting

■

(forward or reverse).

Secure the material to be drilled in a vise or with

■

clamps to keep it from turning as the drill bit rotates.

Hold the drill firmly and place the bit at the point to be

■

drilled.

Depress the switch trigger to start the drill.

■

Move the drill bit into the workpiece, applying only

■

enough pressure to keep the bit cutting. Do not force

the drill or apply side pressure to elongate a hole. Let

the tool do the work.

WARNING:

Be prepared for binding at bit breakthrough.

When these situations occur, drill has a tendency

to grab and kick opposite to the direction of

rotation and could cause loss of control when

breaking through material. If not prepared, this

loss of control can result in possible serious

injury.

When drilling hard, smooth surfaces, use a center

■

punch to mark the desired hole location. This will

prevent the drill bit from slipping off-center as the hole

is started.

When drilling metals, use a light oil on the drill bit to

■

keep it from overheating. The oil will prolong the life

of the bit and increase the drilling action.

If the bit jams in the workpiece or if the drill stalls,

■

stop the tool immediately. Remove the bit from the

workpiece and determine the reason for jamming.

NOTE: This drill has an electric brake. When the switch

trigger is released, the chuck stops turning. When the

brake is functioning properly, sparks will be visible

through the vent slots on the housing. This is normal and

is the action of the brake.

MAINTENANCE

WARNING

When servicing, use only identical RYOBI

replacement parts. Use of any other parts may

English

create a hazard or cause product damage.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING

Do not at any time let brake fluids, gasoline,

petroleumbased products, penetrating oils, etc.,

come in contact with plastic parts. Chemicals can

damage, weaken or destroy plastic which may

result in serious personal injury.

Do not abuse power tools. Abusive practices can damage

tool as well as workpiece.

WARNING

Do not attempt to modify this tool or create

accessories not recommended for use with this

tool. Any such alteration or modification is misuse

and could result in a hazardous condition leading

to possible serious personal injury.