Maintenance And Inspection; Trouble Shooting; Environmental Protection; Available Accessories - Jet JWS-34KX Mode D'emploi

Adjust the shaper fence to suit the tool
diameter used.
The shaper guard (B) should be
positioned above the tool.
The vertical press (A) can be lifted to
its maximum.
Fig 16
Before starting work, check manually
that the cutter rotates freely and that
all components are correctly clamped.
Feed the workpiece by sliding the
carriage towards the tool with both
hands pressing the workpiece onto the
miter gauge profile (E).
Always keep your hands well clear of
the rotating cutting tool.
Note:
Tenoning work requires power and
torque.
In most cases the 3500 RPM
spindle speed will perform best.

8. Maintenance and inspection

General notes:
Maintenance and inspection work
may only be carried out after the
machine is protected against
accidental starting by pulling the
mains plug.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
Defective safety devices must be
replaced immediately.
All protective and safety devices must
be re-attached immediately after
completed cleaning, maintenance and
inspection work.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Drive Belt:
The belt tension must be inspected
regularly.
Motor Break:
The motor break works electro-
mechanically (break motor).
If breaking time should exceed 10
seconds, the motor break assembly
needs to be replaced (JET Stock Nr.:
JWS34-BME).
Contact your Jet service station
immediately.

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or power
cord-
consult an electrician.
*Overload has reacted-
wait 10 min and start again.
*Spindle lock is engaged.
Cutter doesn't come to speed
*Too big or heavy a tool-
choose smaller spindle speed.
*Extension cord too light or too long-
use adequate power supply.
*V-belt excessively tensioned-
apply proper tension.
Wrong spindle direction
*3-phase sequence is wrong-
Push in and rotate phase inverter on
3-phase plug.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Cutter head damaged-
replace cutter head immediately.
Cutting surface is bad
*dull cutter-
replace cutter
*Cutter knives blocked by chips-
remove chips.
*Cutting speed too low-
chose correct speed.
*Too heavy a cut-
make several passes.
*knives cutting against grain-
turn workpiece around.
*Workpiece inhomogeneous.
*Moisture content too high.
Snipe
*Inadequate fence board adjustment-
use spacer board where possible.
9
*Clearance to table hole too big-
use table insert rings.
*insufficient workpiece guiding-
improve hold downs setting.
Spindle quill difficult to adjust
*Lack of lubrication-
lubricate spindle quill
*Quill is clamped.
Poor machining power
*belt is slipping-
tighten belt.
*Resin build up on tables-
clean and wax table surfaces.

10. Environmental protection

Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.

11. Available accessories

Stock number 10000251
30mm spindle arbor incl. spacing
collars.
Stock number 10000252
Sanding spindle with drums and
sanding sleeves dia. 25, 38, 50, 75,
100mm
-refere to the Jet-Pricelist for various
grit sanding sleeves ( see JVOS-10).
Stock number 10000253
Tenoning carriage
Stock number 709207
Foldable roller stand

12. Safe operation

See appendix A (on the last pages of
this operating manual).