Video Settings - Pioneer AVH-120BT Mode D'emploi

Menu Item Description
[Fader/Balance] Touch
[Front] and [Rear] to [0] when using a dual speaker system.
Touch
TIP
You can also set the value by dragging the point on the displayed table.
NOTE
Only the fader can be adjusted when [Rear] is selected as the
speaker mode.
[Source Level Adjuster] Adjust the volume level of each source to prevent radical
[-4] to [+4] changes in volume when switching between sources other
than FM.
Touch
comparing the FM tuner volume level with the level of the
source.
TIP
If you directly touch the area where the cursor can be moved, the
SLA (source level adjustment) setting will be changed to the value
of the touched point.
NOTES
• Settings are based on the FM tuner volume level, which remains
unchanged.
• This function is not available when the FM tuner is selected as
the AV source.
[Subwoofer] Select enable or disable subwoofer output from this
[On] [Off] product.
[Speaker Level] Adjust the speaker output level of the listening position.
1
[Front Left] [Front Right] Touch
[Rear Left] [Rear Right] select the output speaker.
2
[Subwoofer] [Listening Touch
Position] level.
NOTE
For rear speaker, this function is available only when [Rear] is
selected in [Preout].
[Subwoofer Settings] Select the subwoofer phase and LPF cut-off frequency
(page 19).
[Listening Position] Select a listening position that you want to make as the
[Off] [Front Left] [Front center of sound effects.
Right] [Front] [All]
[BASS Boost] Adjust the bass boost level.
[0] to [+6]
or to adjust the front/rear speaker balance. Set
or to adjust the left/right speaker balance.
or to adjust the source volume after
or to select the listening position then
or to adjust the selected speaker output
Menu Item Description
[Loudness] Compensates for deficiencies in the low-frequency and
[Off] [Low] [Mid] [High] high-frequency ranges at low volume.
Adjusting the LPF cutoff frequency value
You can adjust the LPF cutoff frequency value for subwoofer.
NOTE
[Subwoofer Settings] is available only when [Subwoofer] is [On].
1
Press .
2
Touch then .
3
Touch [Subwoofer Settings].
4
Touch or to set the cutoff position.
The following items can also be set.
Switches the subwoofer phase between normal and reverse position.
Switches the LPF setting to [On] or [Off].
LPF

Video settings

The menu items vary according to the source.
[DVD Setup]
This setting is available when the selected source is [Disc].
Menu Item Description
[Subtitle Language]*1*2*3 Set a subtitle language preference. When you select
[Others], a language code input screen is shown. Input the
[Audio Language]*1*2*3
four-digit code of the desired language then touch
[Menu Language]*1*2*3
.
19
En