Maintenance; General Maintenance - Ryobi P423 Manuel D'utilisation

 Remove the battery pack.
 Install cutting wheel guard and cutting wheel.
 Install the battery pack.
 Hold the tool in front and away from you with both hands,
keeping the cutting wheel clear of the workpiece.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning, performing any
maintenance, or when storing the tool.
NOTE: ILLUSTRATIONS START ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
 Turn the tool ON and let the motor and cutting wheel build
up to full speed.
 Move the cutting wheel into the workpiece.
NOTE: Do not force. Use only enough pressure to keep
the tool cutting. Let the wheel and tool do the work.

MAINTENANCE

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
REPLACING THE GUARD
See Figures 1 - 3, page 12.
After extended use, the guard may wear and need replacing.
If you drop the tool and damage the guard it may also be
necessary for you to replace it. Refer to Installing/Remov-
ing Wheel Guard earlier in this manual.
11 — English