Lea LE46517-20S Mode D'emploi page 26

Store the machine, operating instructions and where necessary the accessories in the original packaging.
In this way you will always have all the information and parts ready to hand.
Pack the device well or use the original packaging in order to avoid transit damage.
Store the machine in dry and well ventilated surroundings and with the fuel tank empty. Do not store fuel
next to the machine.
TROUBLESHOOTING
If these solution do not solve the problem, contact your authorized service dealer.
PROBLEM POSSIBLE CAUSE
Engine will not No spark
start No fuel
Engine is flooded
Starter rope pulls harder
now than when new
Engine starts but Engine requires
will not approximately three
accelerate minutes to warm up
sufficiently
Engine starts but Carburetor requires
will only run at adjustment
high speed at half
choke
Engine does not Check oil fuel mixture
reach full speed Air filter is dirty
and emits Spark arrestor screen is
excessive smoke dirty
Engine Idle speed screw on
starts,runs,and carburetor requires
accelerates,but adjustment
will not idle
The auger Idle speed is set too high.
attachment turns Gearbox clutch
at idle
Oil drips from Check oil/fuel mixture
muffler
SOLUTION
Check spark. Remove spark plug. Reattach the
spark plug cap and lay spark plug on metal cylinder.
Pull the starter rope and watch for spark at spark
plug tip. If these is no spark , repeat test with a new
spark plug.
Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked.
Contact a servicing dealer. If primer bulb fills, engine
may be flooded, proceed to next solution.
Set the choke lever to the "START" position.
Squeeze the throttle trigger and pull the starter rope
repeatedly until the engine starts and runs. NOTE:
Depending on the severity of the flooding, this may
require numerous pulls of the rope.
Contact a servicing dealer.
Allow engine to completely warm up. If engine does
not accelerate after three minutes, contact a
servicing dealer.
Contact a servicing dealer.
Use fresh fuel and the correct 2-stroke oil mix.
Clean air filter. Refer to cleaning the air filter earlier
in this manual.
Contact a servicing dealer.
Turn idle speed screw clockwise to increase idle
speed.
Turn the idle speed screw counter clockwise to
reduce the idle RPM and stop the auger attachment.
Contact a service dealer for adjustment and
discontinue use until the repair is made. Serious
personal injury may result from the auger attachment
turning at idle
Use fresh fuel and the correct synthetic 2-stroke oil
mix.
Clean per instruction in maintenance section.
25