Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
-
before refueling
m) Before checking or adjusting the machine, the ignition plug and the ignition wire respectively must be
removed to prevent accidental starting.
n) Do not use of the machine when the operator is tired, ill or under the influence of alcohol or the drugs.
o) Comply with local regulations to use the brush cutter.
p) Contact your local government offices for information regarding minimum age requirements for
operating the equipment.
q) Wear safety goggles and ear protection. Other safety equipment for the hands, legs and feet is
recommended. Correct safety equipment reduces the risk of injury caused by catapulted foreign
bodies or in the event of accidental contact with the brush cutter.
r) Ensure that you maintain a steady foothold. Only use the brush cutter on flat surfaces where you have
a firm footing.
s) While working, always wear substantial footwear and long trousers. Do not operate the equipment
when barefoot or wearing open sandals. Always keep proper footing and operate the brush cutter only
when standing on fixed, secure and level surface.
t)
Always hold the brush cutter with two hands (right hand hold the right handle to control the trigger and
the left hand hold on handle bar). To put hands in wrong positions increases the risk of injury and
must therefore be avoided..
u) Always use the harness when operate the tool, and adjust the length of the harness to ensure it is
suitable for operation.
v) Always use the correct blade and spool recommended by the manufacturer.
w) Take care against injury to feet and hands from the cutting means.
x) Always ensure that the ventilation openings are kept clear of debris
3.4. Maintenance and storage
a) Keep all nuts and screws tight to be sure the equipment is in safe working condition.
b) Never store the equipment with petrol in the tank inside a building where fumes can reach an open
flame or spark.
c) Allow the engine to cool before storing in any enclosure.
d) To reduce the fire hazard, keep the engine, silencer and petrol storage area free of vegetative material
and excessive grease.
e) Replace worn or damaged parts for safety.
f)
If the fuel tank has to be drained, this should be done outdoors.
g) Always clean and maintenance before storage.
h) Never disassembly the guards for cutting attachments.
i)
Always store the metal blade in cool and dry place, never use rusted blade. It may cause serous
injure during working.
3.5. TRANSPORTATION AND HANDLING
a) Whenever the machine is to be handled or transported you must:
–turn off the engine, wait for the cutting device to stop and disconnect the spark plug cap;
–fit the cutting device guard;
–use protective gloves when handling the blades.
–Keep the blade protection device on.
–only hold the machine using the handgrip s and position the cutting device in the opposite direction
to that used during operation.
b) hen using avehicle to transport the machine, position it so that it can cause no danger to persons and
fasten it firmly in place to avoid it from tipping over, which may cause damage or fuel spillage.
4. INTENDED USE
4.1. Intended use
This earth auger is only used for drilling holes on soil ground.
4.2. Non intended use
This machine is not designed for working with ice, excessively rocky ground and especially in an area
which with underground electric, gas, water, or telephone lines.
19
Publicité
Table des Matières
