EINHELL TPR 200/2 Mode D'emploi page 10

Anleitung TPR 200-2 SPK1
GB
(9).
Switch off the tile cutting machine after
completion of cutting.
7.4 45° Diagonal cut (Fig. 10)
Set the angle stop (5) to 45°.
Cut as described in 7.3.
7.5 45° Lengthwise cut, "jolly cut" (Fig.11)
Loosen the star grip screw (10).
Tilt the guide rail (7) to the left to 45° on the
angle scale (17).
Retighten the star grip screw (10).
Cut as described in 7.3.
7.6 Changing the diamond cutting wheel
(Fig. 12/13)
Pull out the power plug.
Unscrew the four screws (35) and remove the
safety hood (8) for the blade.
Using the wrench (34), loosen the flange nut in
the direction of rotation of the cutting wheel (2).
(Caution: Left-hand screw-thread.) To do so,
place the wrench (31) on the motor shaft and
apply counterpressure.
Remove the outer flange (36) and cutting wheel
(2).
Clean the mounting flange thoroughly before
fitting the new cutting wheel.
Fit the new cutting wheel by following the above
procedures in reverse and then tighten.
Caution: Pay attention to the direction of rotation
of the cutting wheel!
Mount the safety hood (8) for the blade again.
8. Maintenance
Clean off all dust and soiling from the machine at
regular intervals, preferably with a cloth or a
brush.
Lubricate all moving parts at regular intervals.
Do not use any aggressive cleaning agents to
clean plastic parts.
Clean off any soiling on the trough (3) and
cooling agent pump (13) at regular intervals,
otherwise the diamond cutting wheel (2) may not
be cooled as required.
10
27.06.2005 9:33 Uhr Seite 10
9. Ordering of replacement parts
When ordering replacement parts, please provide the
following information:
Machine type
Article number of the machine
Identification number of the machine
Replacement part number of the part to be
replaced
For our latest prices and information please go to
www.isc-gmbh.info