Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
To reduce the risk of injury, always
unplug the charger and remove the
battery pack from the charger or tool
before performing any maintenance.
Never disassemble the tool, battery
pack or charger. Contact a MILWAU-
KEE service facility for ALL repairs.
Keep your tool, battery pack and charger in good repair by adopting a regular
maintenance program. After six months to one year, depending on use,
return the tool, battery pack and charger to a MILWAUKEE service facility for:
•
Lubrication
•
Mechanical inspection and cleaning (gears, spindles,
bearings, housing, etc.)
•
Electrical inspection (battery pack, charger, motor)
•
Testing to assure proper mechanical and electrical operation
Maintaining Tool
If the tool does not start or operate at full power with a fully charged battery
pack, clean the contacts on the battery pack and tool with an eraser. If the
tool still does not work properly, return the tool, charger and battery pack to
a MILWAUKEE service facility for repairs (see "Repairs").
Maintaining Battery Pack
MILWAUKEE Nickel-Cadmium battery packs will operate for many years
and/or hundreds of cycles when they are maintained and used according to
these instructions.
A Power Plus Battery Pack that is stored this MILWAUKEE Charger will
maintain its charge because the charger has a maintenance charge feature.
A battery pack that is stored for six months without being used will discharge
itself. Batteries discharge at a rate of about 1% per day. Charge the battery
every six months even if it is unused to maximize battery life. Do not tape the
trigger in the ON position and leave the tool unattended as this may discharge
the battery to a point where it will no longer be able to recharge. Use a
MILWAUKEE battery pack only until it no longer performs with the power and
torque needed for your application.
Store your battery pack in a cool, dry place. Do not store it where the
temperature may exceed 120° F (50° C) such as in a vehicle or metal building
during the summer. High temperatures will overheat the battery pack,
reducing battery life. If it is stored for several months, the battery pack will
gradually lose its charge. One to three cycles of charging and discharging
through normal use will restore the capacity of the battery pack. During the
life of the battery pack, the operating time between charges becomes
shorter. If the operating time becomes extremely short after a proper charge,
the usable life of the battery pack has been reached and it should be
replaced.
To reduce the risk of injury and dam-
age, never immerse your tool, battery
pack or charger in liquid or allow a
liquid to flow inside them.
Cleaning
Clean dust and debris from charger and tool vents. Keep tool handles clean,
dry and free of oil or grease. Use only mild soap and a damp cloth to clean
the tool, battery pack and charger since certain cleaning agents and solvents
are harmful to plastics and other insulated parts. Some of these include
gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning
solvents, ammonia and household detergents containing ammonia. Never
use flammable or combustible solvents around tools.
Page 4
WARNING!
WARNING!
To reduce the risk of explosion, never
burn a battery pack even if it is dam-
aged, dead or completely discharged.
Disposing of Nickel-Cadmium Battery Packs
Nickel-Cadmium battery packs are recyclable. Under various state and local
laws, it may be illegal to dispose of this battery into the municipal waste
stream. Dispose of your battery pack according to federal, state and local
regulations.
Repairs
For repairs, return the tool, battery pack and charger to the nearest service
center listed on the back cover of this operator's manual.
Battery Pack Warranty
Battery packs for cordless tools are warranted for one year from the date of
purchase.
WARRANTY
Every MILWAUKEE tool is thoroughly inspected and tested before leaving
our manufacturing facilities. Should any trouble develop, return the complete
tool prepaid to our Corporate Office, Branch Office/Service Center or
nearest Authorized MILWAUKEE Service Station. If inspection shows the
trouble is caused by defective workmanship or material, all repairs will be
made without charge, and the tool will be returned, transportation prepaid.
Battery packs for cordless tools are warranted for one year from the date of
purchase.
This warranty does not apply where: (1) repairs or attempted repairs have
been made by persons other than MILWAUKEE personnel or Authorized
Service Station personnel; (2) repairs are required because of normal wear;
(3) the tool has been abused or involved in an accident; (4) misuse is evident,
such as caused by overloading the tool beyond its rated capacity; (5) the tool
has been used after partial failure or (6) the tool has been used with an
improper accessory. No other warranty, written or verbal, is authorized.
WARNING!
Publicité
