Ryobi ETS-1526 Mode D'emploi page 20

ELEVATING HANDLE (FIG. 14)
Elevating handle (13) is used to raise and
lower the blade. Turn it clockwise to lower and
counterclockwise to raise it.
The titling handle is used to tilt the blade for
bevel cutting. Turn it clockwise to tilt toward
The head is Iocked in the desired position for
crosscutting or mitre cutting by tightening the
mitre gauge (10). Always lock it securely when
Crosscutting is cutting wood across the grain
at 90° or square with both the edge and the
flat side of the wood. This is done with the
mitre gauge (9) set at "0". Before using it,
make sure it is locked (10). The mitre gauge
(9) can be used on either of the grooves in
MITRE CROSSCUTTING (FIG. 17)
Mitre crosscutting is cutting the wood at an
angle other than 0° with the edge of the wood
on the mitre gauge (fig.17). Follow the same
Bevel crosscutting is similar to crosscutting
except that the wood is cut at an angle other
than the 90° with the flat side of the wood or
COMPOUND MITRE CUTTING (FIG. 19)
Compound mitre cutting is a combination of
mitre cutting and bevel crosscutting. The cut
is made at an angle other than 90° to both the
edge and the flat side of the wood. Adjust the
REPETITIVE CUTTING (FIG. 20&21)
Repetitive cutting is cutting a number of
pieces the same length without having to
mark each piece. Do not feed the workpiece
with your hand (Fig.20). Guide it and make
sure that it does not bind or pinch the saw
blade (Fig.21).
TILTING HANDLE (FIG. 15)
MITRE GAUGE (FIG. 16)
CROSSCUTTING (FIG. 16)
BEVEL CUTTING (FIG. 18)
13
Please note- this handle will move sideways
as the tilt or bevel is adjusted.
the left and counterclockwise to till toward
the right.
in use by turning the mitre gauge lock (10).
the table. To change groove, slide the mitre
gauge assembly out of its groove and into
the other groove. Adjust it to the desired
setting before operating.
procedures as you would for crosscutting.
Adjust the Mitre gauge (9) to the desired
angle.
table (fig.18). Adjust the blade to the
desired angle.
mitre gauge (9) and the blade (15) to the
desired angle and ensure the mitre gauge
(9) is locked by using the mitre gauge
lock(10).
Never use the rip fence (6) as a length stop
because the cutoff piece could bind
between the fence (6) and the blade (15)
causing a kickback.