Eaton Cooper Lighting IRiS P3MR Instructions D'installation page 7

Tilt Arm
Figure 16
Figure 17
Reinstall Mechanism (Figure 18 - 20)
Step 1
To reinstall mechanism, replace the mechanism as
shown in (Figure 18).
N ote: Replacement is easier if the mechanism is tilted
45º angle so that the side with the tilt arm goes
in first.
Step 2
Ensure that the hooks on the mechanism engage the
base located inside the platform (Figure 19).
Step 3
Rotate the clamper back into the original position,
tighten adjustment screw, and replace screw retainer
clip (Figure 20).
Step 4
Reconnect quick connector (Figure 13).
Step 5
Reinstall lamp module assembly (Figure 12).
Step 6
Re-aim according to above "Hot Aiming" instructions.
P3MR Recessed Housing Platform 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 www.eaton.com
Adjustment Screw
P3MR Recessed Housing Platform
Hooks
Figure 18-19
Screw Retainer Clip
Clamper
Locking Screw
Figure 20
7