Fracarro 3DGFLEX Instructions D'emploi page 26

From the second section "Network settings," you can enable or disable the DHCP (the fun-
ction to automatically assign the IP address from the network) and set the new network para-
meters by entering them in the proper boxes; IP, Port, Netmask, Gateway and DNS.
Furthermore, it is possible to display the MAC Address that identifies the device.
NOTE: click the "SAVE" key to apply the modifications
From the green option bar on the top, se-
lect "monitoring" "configuration" and the
following window will appear:
From the Monitoring Configuration menu,
you can set all parameters relevant to the
headend monitoring. The menu is divided
into three sections: Monitoring settings,
Date and Time Settings, Email Settings.
Enabling monitoring: for disabling or ena-
bling the monitoring function,
Saving on a log file: for enabling or disa-
bling the saving on a monitoring file
Duration of the log file: for enabling its du-
ration.
The Empty key allows you to delete all mo-
nitored events from the log file.
Send an alarm email: for enabling or disa-
bling the dispatch of an alarm email in the
event one or more parameters exceeds the operation range you have set.
Date: for setting the date of the headend, by entering it in the proper box.
Time: for setting the time of the headend by entering it in the proper box.
Tuning date and time (NTP): for enabling or disabling the tune of date and time of the hea-
dend with those of the server.
NTP tuning server: for setting the address of the server that is used for tuning the date and
the time of the headend (default: 0.it.pool.ntp.org).
Country time: for setting the time of the installation country.
Smpt server: for setting the support server's address for performing the function of sending
the monitoring email by entering the address in the proper box.
Receiver email: for setting the email address where the monitoring message will be sent.
Addressee email: for setting the email address from which the monitoring message will be
sent (default: 3dg_glex@fracarro.com).
Furthermore, by clicking the key "send test email," you can send a test email to make sure
that the email works properly.
Click the "Save" key to apply the modifications.
26