Fracarro 3DGFLEX Instructions D'emploi page 20

ATTENTION: the default language is English. After resetting, you can set the parameters again
as default parameters might not meet your needs.
The two front LEDs (red and green) of the control unit indicate the module status (i.e. ON,
under alarm, under lockage, under booting or programming). The following table helps
understand the luminous signalizations.
GREEN LED
on
GREEN LED RED LED
on
on
on
4.1 PROGRAMMING FROM KEYBOARD (only for 3DG-BOX version)
The control unit can be programmed by the keyboard. Press the V key and enter the menu;
enter the user's code (1234 by default) and press V again. To change the language of the
menu, enter the main menu "LANGUAGE" and use the V key to select the language.
ATTENTION: make sure that the input signal is locked (see LEDs or program menu) before
saving the configuration by pressing the S key on the keyboard.
If the parameters are saved when the input is unlocked, the whole configuration of the output
MUXs, which use the programs of that input, will be lost.
For programming and understanding the programming menus indicated in the following
flowcharts, refer to the following table:
Keyboard
or
✓ ➤
✗
or
➤
0 9
......
WXYZ
S
IMPORTANT: press the S key to save the set parameters. If the key is not pressed within 5 minutes from
the last modification, the set data will be lost and the previous values will be restored.
LED STATUS – START UP
RED LED
LED STATUS – SYSTEM READY
off
on
on The card in the cabinet does not reply via RS485
For confirming an entered value or exiting the menu
For deleting an entered value or exiting the menu
For navigating among the various items of the menu
on
MEANING
Normal operation
The control unit is faulty.
The control unit has not been tested.
Key function
For changing the parameters
For entering the values
For saving the changes
20
MEANING
system start up