Hach 8398 Série Manuel D'utilisation page 3

Polymetron inductive conductivity sensors
Masquer les pouces Voir aussi pour 8398 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
Table of Contents
1 Specifications
on page 3
2 General information
on page 3
3 Installation
on page 5
Section 1 Specifications
Specifications are subject to change without notice.
1.1 Inductive conductivity sensors
Specification
Application
Material
Cell constant K
Accuracy
Measurement range
Conductivity response
Temperature response
Maximum pressure
Maximum temperature
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
2.2 Use of hazard information
Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
4 Maintenance
5 Replacement parts and accessories
8398 series
Corrosive and fouling applications
PEEK
-1
2.35 (cm
)
± 2 %
0—2000 mS/cm
< 1 second
< 2 minutes
18 bars
140 °C
N O T I C E
D A N G E R
W A R N I N G
on page 6
on page 7
8332
Measurement in harsh conditions
PVDF
-1
10 (cm
± 2 %
100 μS/cm—10 S/cm
< 1 second
< 2 minutes
7.5 bars
120 °C
)
English 3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

8332

Table des Matières