Doxa SUB 200 Mode D'emploi page 14

3 HANDS, DATE, CHRONOGRAPH,
2 COUNTERS, MANUAL WINDING
Your SUB 200 T.GRAPH
features an original
vintage Valjoux 7734
mechanical movement.
You must regularly wind
it by hand. You can set
the time and date
depending on the
crown's position (P).
P1: Wind Manually
Make sure the crown
is tightly pushed back
against the case. Give
the crown a good
number of turns
clockwise until you feel
some resistance. It is
normal for the crown to
spring slightly in reverse
as the mainspring
tightens when the watch
is nearly fully wound.
DO NOT CONTINUE
WINDING ONCE YOU
FEEL SOME RESISTANCE
IMPORTANT
Do not pull the crown
out to set the time or
date when the watch is
submerged or if you are
in a very humid
environment. Do not
14
AS THIS MAY HARM
THE MAINSPRING.
When fully wound, your
SUB 200 T.GRAPH should
have an average power
reserve of 45 hours.
P2: Set Time & Date
To set the time, gently
pull out the crown one
stop to position P2, then
turn it clockwise.
To set the date, keep
turning the crown
clockwise until the hour
hand passes 12 (noon)
and 12 (midnight).
Repeat until you arrive
at the desired date.
Due to the movement's
vintage mechanism, there
is no quickset date feature.
Always be sure to push
the crown back down
operate the chronograph
pushers while the watch
is submerged. Don't leave
your chronograph running
for longer than needed, as
this will deplete the power
against the case to P1
after setting the time and/
or date.
Chronograph
The chronograph
function comprises
the stopwatch and the
30-minute counter
(located at 3 o'clock).
The latter is activated
with the stopwatch,
while the 60-second
(at 9 o'clock) counter
operates continuously.
To track the elapsed time
with the chronograph:
1.
Press pusher C1 to start
the chronograph
2.
Press pusher C1 again
to stop the chronograph
3.
Press pusher C2 to
reset the chronograph.
reserve. Always press the
crown back into the
correct position firmly
against the case once
you have completed your
adjustments.