Installation Of The Indoor Unit - Sygonix 1656670 Notice D'emploi

f) Installation of the indoor unit
• First turn out the two attachment screws (10) for the wall holder with a
Phillips-head screwdriver.
• Then remove the wall holder (14) on the rear of the indoor unit. Remember
the orientation.
• Guide the connection cables through the opening of the wall holder
(14).
• Attach the wall holder to the wall with four screws and, if required,
dowels.
Observe correct alignment of the wall holder, see figure to the right.
Ensure that no cables or lines are damaged when drilling or screwing.
• Connect the cables as in the connection chart in chapter 6. b) or 6. c).
Observe correct polarity, since the indoor unit and the outdoor unit will be damaged otherwise. Loss of
warranty/guarantee!
• Put the indoor unit onto the wall holder and fasten it with the two screws (10) removed at the start.
37