Mains Adapter; Indoor Unit; Outdoor Unit - Sygonix 1656670 Notice D'emploi

Interphone vidéo
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

b) Mains adapter
• The mains adapter is constructed pursuant to protection category II.
• Only connect the mains adapter to proper mains sockets of the public mains.
• The mains socket for the plug-in mains adapter must be close to the indoor unit and easily accessible.
• The plug-in mains adapter is intended for use in a dry, closed indoor room; it must not become damp or
wet. There is danger to life from electric shock!
• Do not pull the plug-in mains adapter from the mains socket by pulling the cable.
• Protect the cables of the plug-in mains adapter from sharp edges, do not step on them.
• If the mains adapter is damaged, do not touch it. Danger to life from electric shock!
First deactivate all sides of the mains socket to which the plug-in mains adapter is connected (e.g. switch
off the respective fuse or turn out the fuse. Then deactivate the associated FI protection switch).
Then unplug the mains adapter from the mains socket. Replace the damaged plug-in mains adapter with
a new one of the same build.
c) Indoor unit
• The indoor unit is only suitable for dry, closed rooms. Do not expose it to direct sunlight, heat, cold, dust,
dirt dampness or wetness; otherwise, it will be damaged.
• Never cover the ventilation openings on the back.
• Do not push the display surface too hard. This will not only leave scratches, but the display may also
break and be permanently damaged. Loss of guarantee/warranty!
d) Outdoor unit
• The outdoor unit is suitable for indoor and outdoor use (IPX4). However, it must never be operated in or
under water; it would be destroyed by this.
• Install the outdoor unit in the outdoor area under an advancing roof (e.g. an awning).
• Ensure that the connection cables are not crushed, bent or damaged by sharp edges.
• Install the outdoor unit so that the integrated camera does not point right at bright light sources (e.g. the
sun or spotlights). This will not only cause an overmodulated and useless image, but also may damage
the image sensor it permanently exposed.
• Before installation of the outdoor unit, observe any applicable provisions for whether operation of the
camera or its alignment with a specific area of the environment is permitted.
27

Publicité

Table des Matières
loading

Table des Matières