Sygonix 1656670 Notice D'emploi page 35

Interphone vidéo
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Ensure that no cables or lines are damaged when drilling or screwing.
Apply suitable sealing where the cable comes out of the wall, so that water running down the wall (e.g. rain)
cannot run into the wall along the cable. Use a little silicone for sealing.
• Connect the cables as in the connection chart in chapter 6. b) or 6. c).
Always observe proper polarity for the terminals "C+" and "C-", since otherwise both the indoor unit and the
outdoor unit will be damaged; loss of warranty/guarantee!
The polarity does not matter in conventional door openers, in contrast.
Observe that a door opener (operating voltage 12 V) can be connected directly to the screw terminals
"D/O". No further external wiring is necessary.
The screw terminals "GATE" in contrast are potential-free. Only an internal relay is switched here (for
contact resilience, see chapter "Technical data").
• Alignment of the camera can be set. For this, the round camera housing can be carefully turned to the left, right,
up or down.
• The dial switch (22) can be used to set the playback volume via the speaker (turn to the left counter-clockwise
= volume down, turn to the right clockwise = volume up). For initial commissioning, do not adjust the dial switch.
• The dial switch (23) can be used to set the microphone sensitivity and thus indirectly the volume on the indoor unit
(turn to the left counter-clockwise = reduce sensitivity, turn to the right clockwise = increase sensitivity). For initial
commissioning, do not adjust the dial switch.
• Put on the front plate again and carefully push it into the clamp holder so that the bottom edge of the front plate
ends flush with the lower plastic edge.
• Fasten the front plate with the two screws removed before (19).
Observe that you do not accidentally turn the right screw into the opening for the microphone labelled "mic"!
Loss of guarantee/warranty!
• To protect from moisture, apply a little silicone on the upper end of the outdoor unit between the aluminium frame
and the wall. This prevents that water running down the wall will run along the cable and into the outdoor unit.
35

Publicité

Table des Matières
loading

Table des Matières