Testing The Rccb - ABL Wallbox eMH1 Mode D'emploi Et Consignes De Sécurité

24
| Wallbox eMH1 – Testing the RCCB

Testing the RCCB

To ensure the continuing safe operation of the wallbox, the function of the RCCB must be tested regularly
according to locally applicable regulations (e.g. every 6 months in Germany): For this purpose, the RCCB
has a push button with which to initiate the test function.
NOTE
ƒ The Wallbox eMH1 is available with or without integrated RCCB.
ƒ Should your Wallbox eMH1 not have an integrated RCCB, one must be present upstream in the
domestic power supply.
Proceed as follows to test the RCCB:
1
Open the housing cover of the wallbox using
the key supplied and flip it up.
y Wallboxes without integrated RCCB:
The RCCB must be installed upstream in
the domestic power distribution: open the
domestic power distribution box.
2
Locate and press the push button engraved
T or marked Test.
y The RCCB should now trip and flick
its pivot lever into the centre position
(connection to the electricity grid is
interrupted).
3
Now flip the pivot lever first to the 0 position
and then back to the I position.
4
Close the housing cover of the wallbox and/
or the domestic power distribution box.
Danger
Dangerous electrical currents
Should the RCCB malfunction during testing, you must not continue to operate the wallbox under any
circumstances!
ƒ Contact a qualified specialist electrical contractor to have the error resolved.