Ordering Replacement Parts - EINHELL SPU 80/1 Mode D'emploi

Anleitung SPU 80-1 15.01.2004
Operation of the cascade fountain and the water
spout connection: (see Figure 1)
Install the pump as described above. Additional
water spectacles can be connected to the water
spout connection with a hose of 9 mm inner diameter
or 13 mm diameter.
To open the spout connection, turn the
shut-off cock (A) anticlockwise.
1
Operation only with the water spout connection:
(see Figure 2)
In this case you must turn the entire connection (B)
through 90°. All the water will then flow through the
spout connection and none through the fountain.
2
13:54 Uhr Seite 5
8. Maintenance
Regular inspections and servicing are
recommended in the interest of a long working life
without interruptions.
If you notice any reduction in the delivery height
or delivery rate, clean the filter with luke warm
water.
If the water has a high lime content, clean the
rotating parts in regular intervals

9. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
GB
5