Using For The Fi Rst Time; Cleaning, Maintenance And Ordering Spare Parts; Ordering Replacement Parts - EINHELL AQUINNA 36/30 Instructions D'origine

When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.5 Battery capacity indicator (Fig. 4)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs fl ash:
The battery pack has undergone exhaustive
discharge and is defective. Do not use or charge
a defective battery pack.
6. Operation
6.1 On/Off /Pump setting switch (Fig. 1/Item 5)
Switch position 0: Off
Switch position I: Pump setting 1
Switch position II: Pump setting 2
Important!
Selecting pump setting 2 increases the maximum
delivery pressure, but it reduces the maximum
operating time of the battery as a result.
6.2 Using for the fi rst time
•
Install the equipment on a solid and level
surface.
•
Fill the pump housing with water via the
water filler screw (3). Filling the intake line will
accelerate the priming process.
•
All the shut-off devices in the discharge
line (spray nozzle, valves etc.) must be fully
opened during intake in order to permit all air
Anl_Aquinna_SPK9.indb 21 Anl_Aquinna_SPK9.indb 21
GB
to escape from the intake line.
•
The intake process starts automatically after
you have pressed the On/Off/Pump setting
switch (5). Water can be suctioned in for up to
5 minutes (maximum suction height).
•
If the pump is removed after use, it is
essential that it is filled with water again the
next time it is connected and started.
Switch the pump off again after use by pressing
the On/Off /Pump setting switch (5) again and al-
low the pump to cool down.
7. Cleaning, maintenance and
ordering spare parts
The equipment almost completely maintenance
free. In order to ensure a long service life,
however, we recommend regular checks and
product care.
Danger!
Always remove the batteries before starting any
cleaning work.
7.1 Maintenance
•
If the equipment becomes clogged, connect
the discharge line to the water line and
disconnect the intake line. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clog-related problems.
•
There are no other parts inside the equipment
which require maintenance.

7.2 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 21 -
25.05.2020 07:33:07 25.05.2020 07:33:07