Troubleshooting Guide - EINHELL AQUINNA 36/30 Instructions D'origine

11. Troubleshooting guide

Problem
The motor does not
start up
Pump not priming
Insuffi cient pumping
rate
Thermostat
switches off the
pump
Anl_Aquinna_SPK9.indb 24 Anl_Aquinna_SPK9.indb 24
GB
Possible cause
Battery is not correctly inserted
Impeller blocked, thermostat has
switched off
Intake valve not in the water
Pump housing without water
Air in the intake line
Intake valve leaking
Intake cage (intake valve) blocked
Max. intake height exceeded
Intake height too high
Intake cage soiled
Water level falling rapidly
Pump performance reduced by
foreign bodies
Battery performance decreasing
Motor overloaded, excessive friction
caused by foreign bodies
- 24 -
Remedy
Remove battery and insert again
Take pump apart and clean it
Place intake valve in water
Fill pump housing with water
Check sealing of intake line
Clean intake valve
Clean intake cage
Check intake height
Check intake height
Clean intake cage
Place intake valve lower down
Clean pump and replace wear parts
Check the battery performance and
charge the battery if necessary
Dismantle and clean pump, prevent
intake of foreign bodies (fi lter)
25.05.2020 07:33:08 25.05.2020 07:33:08