Stimulation Intensity - Globus Elite 2 PRO Manuel D'utilisation

Time display.
During programme execution, the display shows
the remaining time of the phase in progress.
Programme Time,
Modification.
Press the Function Fn key several times to select
the parameters.
Pressing the Fn key 1 time: phase duration modi-
fication.
Once the programme is started, the phase dura-
tion can still be modified. To change the phase
duration, press the Fn key; the time of the phase
in progress begins to blink.
Modify the time by pressing the P+ or P- buttons.
The set time will automatically be confirmed
after being displayed for 5 sec.
Pressing the Fn key 2 times: frequency modifica-
tion of the programme in progress.
The second time the Fn key is pressed, the word
FREQ is displayed and the value starts to blink.
Change the frequency by pressing the P+ or P-
buttons of the Joypad. The set frequency will
automatically be confirmed after being displa-
yed for 5 sec.
Pressing the Fn key 3 times: width modification of
the programme in progress.
The third time the Fn key is pressed, the word
WIDTH is displayed and the value starts to blink.
Change width by pressing the P+ or P- buttons of
the Joypad. The set width will automatically be
confirmed after being displayed for 5 sec.
Phase skipping.
In order to skip to the following phase before the
end of the phase in progress, press the button
--> for three seconds. To return to the previous
phase, press the button <-- for three seconds.
Increase/decrease intensity.
To increase/decrease channel intensity, press
the Up or Down buttons of the corresponding
channels.
Frequency and Width
Keypad lock.
Once the desired intensity level has been rea-
ched, the keypad may be locked to prevent
accidental use.
Simultaneously press the Fn button and the Ch 1
intensity increase button for 3 seconds. the lock
symbol (a key) appears on the display and all
the buttons are locked except the ON/OFF but-
ton. When the keys are locked, it is impossible to
increase or decrease the intensity or change the
programme. To unlock the keys, press the same
combination of buttons (Fn button + Ch 1 inten-
sity increase button) again for 3 seconds. The
lock symbol (a key) disappears and all the but-
tons can be used, again.

STIMULATION INTENSITY

Open circuit
The device is provided with a current supply con-
trol system. If the intensity value is increased to
over 10 mA and the current circuit is open
(cables not connected to the device and elec-
trodes not in contact with the skin), the electro-
stimulator immediately brings the intensity value
back to 0 mA.
Before beginning any treatment, make sure that
the cables are connected to the device, that
the electrodes are applied to the area to be
treated and that they are in good condition so
as not to prejudice their conduction capacity.
Stimulation intensity
The value of the necessary current intensity to
obtain a certain contraction is determined on an
individual basis, as it can depend on the positio-
ning of electrodes, the adipose layer, sweating,
hairy areas, etc.
Page 35 -
Rev. 1.0
ENGLISH