Vacuum Sealing; Vacuuming The Tube Film - SilverCrest SV 125 C3 Mode D'emploi

Vacuum sealing

Vacuuming the tube film
You can also suck the air out of the bag (vacuum) during welding:
NOTE
► If you want to vacuum seal bags with liquid contents only, it is best to
freeze the liquid briefly so that it does not get sucked into the appliance
during vacuuming. If small quantities of liquid or food nonetheless get
sucked up, they will be deposited in the small drip tray that is located
within the lower sealing ring 5.
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. Otherwise the vacuuming and welding will not function correctly:
2) Close the appliance lid 1. Ensure that both corners of the appliance lid 1
click closed. If necessary, press them down once again on the markings
and
SV 125 C3
so that the appliance lid 1 clicks into place and locks shut.
GB │ IE │ 13 ■