Microphone Jack - Kenwood TK-7480 Mode D'emploi

(Power) switch
①
Press to switch the transceiver ON. Press again to switch the transceiver
OFF.
/ keys
②
Press to activate their programmable functions {page 7}.
Display
③
Refer to page 6.
/ keys
④
Press to activate their programmable functions {page 7}.

Microphone jack

⑤
Insert the microphone plug into this jack.
Transmit/ Busy/ Call indicator
⑥
Lights red while transmitting, green while receiving, and orange while receiving
a call using optional signaling.
, S, A, <B, C>, ■ keys
⑦
Press to activate their programmable functions {page 7}.
⑧
a) Speaker (TK-7180/ TK-8180)
Internal speaker.
b) DTMF Keypad (TK-7189/ TK-8189)
Press the keys on the keypad to make DTMF calls {page 18} or to activate
their programmable functions {page 7}.
PTT (Push-to-Talk) switch
⑨
Press and hold this switch, then speak into the optional microphone to call a
station.
Antenna connector
⑩
Attach the vehicle antenna to this connector {page 3}.
ACC. (accessory) connector
⑪
Connect external KENWOOD accessories to this connector.
SP (speaker) jack
⑫
Connect an external speaker to this jack.
Ignition sense line
⑬
Connect the vehicle ignition sensor to this line.
Power input connector
⑭
Attach the supplied DC power cable to this connector {page 3}.
5