Beta 1497L Mode D'emploi page 8

Beta
OPERATION AND MAINTENANCE MANUAL
INTRODUCTION
This device is designed to properly centre the
headlights of any motor vehicles.
The machine must be used for that purpose
only. Even the best machine can work well and
efficiently only if it is used correctly and kept in
perfect working order. Therefore, please read
this instruction booklet carefully, and read it
again whenever any difficulty should arise in
using the machine. We would like to remind you
that our assistance centres, organized in co-
operation with our dealers, would be delighted
to give you any tips you should require.
NOTE: In order to adjust the device to
technological progress and allow it to satisfy
special manufacturing or installation
requirements, the manufacturer may decide to
make changes to it without notice. Hence, even
if the illustrations contained in this manual
should slightly differ from your device, safety as
well as the information on it are guaranteed.
SPECIFICATIONS
Breadth
Length
Height
Weight
Power supply
SYMBOLS USED IN MANUAL
Warning symbol
For the safety of both the operator and
the machine, please read the sections
preceded by this symbol carefully.
INSTRUCTIONS
ART. 1497
HEADLIGHT TESTER
U/M
mm 600
mm 670
mm 1740
kg 30
V DC 9
MACHINE PREPARATION
HANDLING PACKED MACHINE
The machine is held in a special type of
packaging.
No more than two containers are allowed to be
put on top of each other.
Weight: 30 kg.
Dimensions:
B: 620 mm
L: 1720 mm
H: 310 mm
HOW TO UNPACK MACHINE
Open the packaging from above; slightly tilt it to
take out the device.
Keep the packaging in case the machine needs
to be transported.
EQUIPMENT DESCRIPTION
The headlight tester can be used to test the
headlights of any motor vehicles, including cars
and lorries.
The headlight tester can also be used as a
travelling device, with a base mounted on
rubber castors.
GB