Lega DV2 Guide D'instructions page 16

SAFETY STANDARD OPERATION
(key on the left not inserted, key on the right rotated to the left – step by step mode with two buttons
Press and hold down both the cycle start button
(fig. 1 A) and that on the left control panel.
The chain continues to move forward (step by step operation) as long as the buttons are pressed and held down.
It is also possible to load the frames after the uncapping machine has been started, in a continuous manner.
If a frame gets stuck, turn the main switch (fig. 1 C) to the left.
Hold down the 'start cycle' green button on the left of the machine (fig.1.1) so that the frame moves back,
then re-place the frame correctly.
To stop the uncapping machine, turn the main switch (fig. 1 C) to its 0 position.
NON-STANDARD OPERATION 1 – FOR THE MAINTENANCE STAFF ONLY
(key on the left inserted and rotated, key on the right rotated to the left – step by step mode with one button
only
Press and hold down only the cycle start button on the right
(fig. 1 A).
By rotating the speed selector
(fig. 1 B) to the right, the machine will operate in the FORWARD mode; by rotating the
.
selector to the left (fig. 1 C) the chain will move in the opposite direction in the continuous operation mode
NON-STANDARD OPERATION 2 – FOR THE MAINTENANCE STAFF ONLY
(key on the left inserted and rotated, key on the right rotated to the right – continuous operation mode
By rotating the speed selector
(fig. 1 B) to the right, the machine will work in the continuous FORWARD mode; by
.
rotating the selector to the left (fig. 1 C) the chain will move in the opposite direction in the continuous operation mode
In case of danger, push the emergency button on the right of the control panel.
The emergency stop shall prevail over all other functions and operations.
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
16 / 40